The correct use: anti-mold paint

- Colored varnish 3in1
- possibly painter's tape to mask the surface not to be coated
- Paint roller, brush or cup gun
- if necessary a thinner (this can also be used afterwards to clean the device)


    Preparations and processing:

    1. The processing and especially the drying of the 3in1 paint should not take place below 10°C. This information refers to the paint material, substrate and room temperature during processing and the subsequent drying and curing time.
    2. Sources of dust should be removed.
    3. Use painter's tape to mask off the areas that should not be coated. Stir the paint well before use.
    4. The surface must be sanded before use and must be clean, dry, free of grease, silicone and wax. You should definitely remove any loose old paint or rust beforehand. Important: Do not use soapy cleaners or scouring milk. These are made from fatty acids and are therefore not suitable for dissolving fat.
    5. A primer is not necessary.
    6. If desired, dilute the 3in1 varnish with approx. 5 - 10% thinner.
    7. Spray, roll or brush the paint. One or two coats are recommended.
    8. The paint is dust dry after 24 hours. The product can then be painted over.

    Ready for your project? Whether yellow, green or blue, gray or in over 200 different RAL colors; we offer you a large selection of high-quality colored paints 3in1.

     

    Now available for selection!